After the TREAD Act to be mandated in 2007, every vehicles made in the united States start in 2008, have to be installed with direct or indirect TPMS systems.

You are watching: Ford escape low tire pressure light

The Ford Escape supplies a straight TPMS system, which means TPMS sensors are mounted in the wheel. If one or much more tires indicate low tire pressure, the TPMS sensors will transport the information to the vehicle’s ECU. An indicator light (low-line TPMS system) or each tire push will display on the dash (high-line TPMS system).

When one or much more sensors are changed in a Ford Escape, a TPMS relearn is recommended to write the ID’s to the vehicle’s ECU to revolve the TPMS light off.

See more: Does Saturday Mass Count For Sunday, Sunday Mass Obligation

*

Type the TPMS system: 

Direct TPMS, TPMS sensors are installed in the wheel, tire pressure is connected via radio frequency (RF) technology from the sensor to the vehicle’s ECU. 

Type of TPMS frequency: 

315 MHz

Type of Relearn procedures: 

Manual, 2 types, conventional ignition, and also push-button startBonus OBD relearn procedure coverage as an option on the VT56 because that years 2014-2019, needs OBD module 

Type of TPMS tool required for TPMS reset:

Manual relearn procedure (standard ignition):

Engage the parking brake and inflate all tiresTurn ignition to the turn off positionPress and also release brake pedalQuickly turn the ignition from turn off to run (engine OFF) three times, stop in run positionPress and also release brake pedalTurn ignition OFFQuickly rotate the ignition from turn off to operation (engine OFF) 3 times, avoid in run positionNOTE: all the measures for this procedure must be performed in ~ 10 secondsA solitary horn chirp will indicate the relearn mode is activeUse her TPMS device to activate the left prior sensorA solitary horn sound to indicate learning successfulRepeat for the RF, RR, and also LR sensorsTRAINING MODE complete will screen on the message center when relearn is finished

Manual relearn procedure (push-button start):

Important note, some models call for the start button to be pressed double (without pushing the brake) to enter RUN mode (Ignition ON/Engine OFF). If this is the case, modify steps 3 and also 5 together noted.Engage the parking brake and also inflate every tiresWith the automobile OFF, push and also release the brake pedalPush START switch 5 times (NOTE: 8 times if 2x-to-RUN)Press and also release the brake pedalPush START switch 6 time (NOTE: 9 times if 2x-to-RUN)A single horn chirp will indicate the relearn mode is activeUse the device to activate the left former sensorA single horn sounds to show sensor learning successfulRepeat for best front, appropriate rear and left rear tiresTRAINING MODE complete will display screen on the message facility when relearn is finished

The video clip shows a Ford Edge, however the very same procedure will occupational on a Ford Escape 

OBD relearn procedure, year 2014-2020:

OBDII module is required, connect to the toolConfirm TPMS sensors are effectively installedAdjust tire pressure to placard valueHold TPMS tester top top left front tire sidewall next to the valve stem, usage TPMS device to activate the sensorRepeat because that the appropriate front, best rear and left rear sensorsApply OBD module come DLCTurn ignition to ONPress ok on TPMS device to deliver data to ECUDisconnect OBD module native DLCTurn ignition turn off then begin the engineDrive for at least 5 minutes at 28 mph

The video clip shows a Ford Focus, however the very same procedure will occupational on a Ford Escape 

Troubleshooting tips

Lowering driver’s side window may aid to complete this procedure on bigger vehicles. Ford escape vehicles, year 2014-2019, can be reset via an OBD relearn procedure, as a “bonus” relearn making use of the VT56 or VT46 brands v OBD module. The OBD bonus relearn, known as Sync i would technology, eliminates having to carry out a manual, relearn procedure or auto relearn, which needs either many steps or lengthy driving time to rotate off the TPMS light. If “OBD RELEARN” is an option, the sensor ID’s have the right to be transferred v the OBD port. ATEQ expects to boost the bonus OBD coverage gradually for Ford.After the OBD relearn is completed, you might be forced to activate the sensors again to rotate the TPMS light turn off to stop driving the vehicle to rotate the TPMS light off.Ford to escape vehicles may require the start button to it is in pressed twice throughout the relearn (without pushing the brake) to enter into operation mode during the relearn (Ignition ON/Engine OFF). If this is the case, modify procedures the hand-operated steps for the push-button begin relearn, 3 and also 5, as detailed in the relearn procedure.